Screw Conveyors, Screw Flights

These screw conveyors are used for conveying products. These screw conveyors are made by pulling and drawing cold sheets. They don´t have internal shafts. There are right and left screw conveyors. The below table shows diameter, pitch, internal shaft diameter, thickness and 1 meter weight of screw conveyors. These screw conveyors can be prepared according to your specified dimensions. The direction of screw conveyors can be detected as such: Place your finger on starting point of screws and then follow the path of screws. If your finger is rotating towards right, then it is a right screw conveyor. If your finger is rotating towards left, then it is a left screw conveyor. In general, diameter and pitch of the screw conveyors are similar. There are cold rolled (DKP) and stainless ome screw conveyors.

The following dimensions are required for making screw conveyors: 

Diameter a) ..........

Pitch b) ..............

Internal shaft diameter c) ........

Right or Left? d) ...........

Thickness? ..........

Table of Screw Conveyors

U-Boat Helezons

BEARING HOUSE WITH PLASTIC BUSH
40 mm
50 mm
60 mm

Bearing House
40 mm
50 mm
60 mm

BEARING HOUSE

40 mm

50 mm

60 mm

PLASTIC BUSH

35 mm
40 mm
50 mm
60 mm
70 mm